Dansensor® CheckMate 3 EN User Guide 29
P/N 300042-I
05/2019
The needle
may sometimes touch the product being measured or the needle may suck
fluid from the packaging from which the measurement is taken. If this happens, it will be
necessary to replace both the needle and the filter.
If there is any dirt or fluid in the measuring gas hose
, it should be replaced or cleaned
using dry compressed air.
All of the parts can be ordered (and replaced) separately or as a complete kit.
See "Consumable parts and options" on page 56.
Replacing printer paper
(Only models with printer)
To replace printer paper roll do the following:
1. Open the paper roll tray
by pulling it outwards, then remove the empty paper roll.
2. Place new paper roll
in the tray and lead the paper into the lower paper slot until
the printer catches it.
3. Press the key a couple of times until paper is led out through the upper paper slot
.
4. Close paper tray
.
CAUTION! Do not touch the paper tear-off mechanism located at the top of the
upper paper slot
as there is a risk of cutting your fingers.
To Next Page
Loading...
