40 User Guide EN Dansensor® CheckMate 3
P/N 300042-I
05/2019
Serial data dump specification
Each measurement is on one line terminated with a Carriage Return + Line Feed characters
(ASCII 0x0D, 0x0A).
The line consists of data separated by semicolons (";"). Last parameter is also followed by a
semicolon.
In the "Data log setup...” (see page 38) it can be selected whether the output format should be
ASCII or UNICODE.
When set to ASCII some international characters might come out as wrong ASCII characters.
The table on the next page shows which data is presented and the order of the data.
NOTE! For this function to work properly you must ensure that the “COM1=”
parameter in “General setup” is set to “Normal”.
To Next Page
Loading...
