Ametek mocon Dansensor CheckMate3 User Manual

Dansensor® CheckMate 3 EN User Guide 39
P/N 300042-I
05/2019
Print each measurement Yes Printer will print a header and subsequently each
logged measurement will be printed automatically line
by line
No Function deactivated
Mark measurement Yes After each measurement performed in either Auto spot
as invalid or Manual spot mode you will be asked if you want to
mark measurement as invalid.
No Function deactivated
Network logging setup Network logging Select whether or not network logging is
required.
Server IP Set up an IP-address to be used for
collecting log data for each measurement
via LAN.
This requires for setting up of a Server Port
number as well.
Server Port See above.
If Server IP or Server Port or both are set to 0 the function is
deactivated and data will only be send to the COM-port.
Acknowledge Acknowledge byte can be used if a
“handshake” is required for each
measurement between device and server,
each to be set up to same value.
If value is set to 0 function is deactivated.
Function can be used together with the TCP Wedge or TCP
File from Taltech, TCP File from Fogsoft or a proprietary
setup TCP/IP server.
Data is send out in same format and setup as for the COM-
port.
Data out format Format Select between ASCII or UNICODE
Data out Select which parameters are required for the data output.
Selected data is always send to the device’s COM-port and if a
server has been set up in Network logging (see above) data is
send here as well.
When using RS-232 COM port setting must be: 57600,N,8,1

Ametek mocon Dansensor CheckMate3 Specifications

General

Brand	Ametek
Model	mocon Dansensor CheckMate3
Category	Laboratory Equipment
Language	English