Ametek mocon Dansensor CheckMate3 - User Setup

Dansensor® CheckMate 3 EN User Guide 43
P/N 300042-I
05/2019
User setup
Selecting User setup... from the General setup menu will display a screen showing the User
setup parameters.
From here the user database is maintained. You can see a list of existing users, edit the
settings for an existing user, create new users or delete users.
Users are created with a unique User name (max. 20 characters) and a unique login User ID
(max. 40 characters).
The set-up of the login function is defined according to table below:
User log in Log in with ID Function
No No
No login required (default setting)
At start-up the device will automatically run the
self-test and warm-up period and when finished
it changes to show the measuring screen and
will be ready for measuring.
Ye s N o
User login required
At start-up you are prompted to select user from
appearing list and when done the device will
run the self-test and warm-up period and when
finished it changes to show the measuring
screen and will be ready for measuring.
Ye s Ye s
Login with User ID required
At start-up you are prompted to enter User ID
either by keying it in from the touch screen
keyboard or by using a barcode scanner
(option).
When done the device will run the self-test and
warm-up period and when finished it changes
to show the measuring screen and will be ready
for measuring.
No Yes
Not possible!
Setting User login to No will automatically
change Login with ID to No.
User setup
13:46
08/17/06
Show users
Edit user
New user
Delete user
User log in: Yes
Log in with ID: Yes