A-4 | Thermox TM 2000 Oxygen Analyzer
Read Date and Time (M)
This command is used to read the dates and times stored in the Series
2000 Controller. The data consists of a single digit where 0 is used to read
the current date and time, 1 is used to read the date and time of the last
calibration, and 2 is used to read the date and time of the last verification.
Date and time is returned as mm/dd/yy hh:mm in 24 hour (military) time.
Set Date and Time (N)
This command is used to set the Series 2000 Controller current date and
time. The data string is of the form: mm/dd/yy hh:mm in 24 hour (mili-
tary) time. Leading zeroes are required, for example: 03/18/93 20:02.
To Next Page
Loading...