Ametek Thermox TM2000 - Aborting a Calibration

To Next Page

To Previous Page

5-4 | Thermox TM2000 Oxygen Analyzer

• Temporarilyenableordisableautocalibrationsorverifications(SetCal

Timers/Auto Cal On/Off).

• Definehowlongcalibrationgasesshouldbeappliedtothesensordur-

ing an auto calibration or verification (Set Cal Timers/Cal Gas Dura-

tion).

• Definerecoverydurationtimes(SetCalTimers/RecoveryDuration).

• Defineverifygasvaluestomatchknownvaluesofverifygascylin-

ders; enter acceptable verify range (Configure Verify).

Aborting a Calibration

If you press the Calibrate key while the system is performing a calibration,

you will be have the option to either abort or to continue the calibration.

All other menu functions are temporarily disabled during a calibration