Ametek Thermox TM2000 - Installation and Start-Up; Unpacking

Installation and Start-Up | 3-1
INSTALLATION AND START-UP
The operations in this chapter should be performed only by qualified
service personnel experienced with electrical safety techniques. There
are no operator-serviceable components inside the TM2000 system,
and an operator should never open the sensor or controller covers.
Qualified service personnel should never service the controller or sen-
sor unless power has been disconnected from the controller and sensor,
and the sensor has been allowed to cool for at least one hour. Also,
always use gloves when working on the sensor.
This chapter shows how to install the TM2000 oxygen monitoring system.
This includes the following:
• InspectShippingContents
• MechanicalInstallation
• Wiring
• OptionModuleInstallation
Unpacking
Remove any packing material from the sensor and control unit. Check for
damage. If any damage is found, notify the shipper.
NOTE
