To Next Page
R
reevespatrickSep 9, 2025
What to do if the Ampac Control Panel earth fault LED is illuminated?
- AAmanda HerreraSep 9, 2025
If the Earth Fault LED is illuminated, check all input and output cabling and wiring assemblies for shorts to ground.
What to do if the Ampac Control Panel earth fault LED is illuminated?
If the Earth Fault LED is illuminated, check all input and output cabling and wiring assemblies for shorts to ground.
What to do if the Ampac ZoneSense Plus Control Panel warning system fault LED is illuminated?
If the Warning System Fault LED is illuminated, verify that the correct E.O.L. is fitted and that the wiring is connected correctly.
How to fix alarm fault on Ampac ZoneSense Plus?
To address an alarm fault, ensure you have a 10K Ohm EOL resistor fitted and a diode (1N4004) in series with the sounder.
What to do if there is no mains power on Ampac ZoneSense Plus Control Panel?
If there is no mains power, check the mains fuse.
Provides an overview of the ZoneSense PLUS FACP, its standards compliance, and key features.
Details mounting the FACP enclosure, chassis fixing, and environmental considerations for installation.
Covers primary power supply, mains wiring, battery charger, secondary supply, and connection procedures.
Explains the main control card, its layout, and detailed wiring configurations for modules and interfaces.
Guides users through status, test, disable screens, and system programming levels for the FACP.
Provides a troubleshooting chart for common problems and guides for calculating battery capacity and power requirements.
Outlines installation, commissioning procedures, reports, and compliance declarations for the FACP.
Details mechanical, environmental, electrical, and output specifications for the ZoneSense PLUS FACP.
Describes steps for handling incoming alarm conditions, including sounder silence and reset operations.
Outlines the manual's purpose as an instructional tool and defines the scope of information provided.
General| Zones | 8 zones |
|---|---|
| Sounder circuits | 2 sounder circuits |
| Users | 50 users |
| Humidity Range | Up to 95% RH, non-condensing |
| Certifications | EN54-2, EN54-4 |
