I cannot tell if MU-MIMO simultaneous data transfers are enabled and functioning.
a) Check that the connected devices support MU-MIMO technology. All connected devices must also
support MU-MIMO to enable the MU-MIMO function. If the connected device does not support MU-
MIMO it will function as a SU-MIMO (single-user MIMO) device.
I cannot connect my Windows Vista computer to the wireless network. I enter my wireless password and I
see an error.
a) Manually add a wireless network to your Vista computer:
- Click Start, and then click Network.
- Select Network and Sharing Center.
- Click Manage Wireless Networks.
- Click Add and select Manually create a network profile.
- Type in the SSID, and select the type of security and enter your security key.
- Select “Start this connection Automatically” and click Next.
- Go to Network and Sharing Center and select Manage Network Connections.
- Right click Wireless Network Connection and then select Status.
- Click details and check to see that your IPv4 IP address is correct (192.168.3.x).
b) Disable IEEE 802.1x authentication on your computer.
To Next Page
Loading...
