AMX DAS-M-0404 - Page 86

RS-232 Commands / Messages
76
Mi Series Audio Controllers
Controller Status Messages (Cont.)
MGSTr,v,bb,t,s,
r,z,l,p
General Status, where:
•‘r’ denotes the room, (1-64)
•‘v’ denotes the volume setting, valid values are:
101: Mute
100...0: -100...0 dB
•‘b’ denotes the bass level, valid values are:
0: level
1...10: -10...-1 dB
11...20: 1...10 dB
•‘t’ denotes the treble level, valid values are:
0: level
1...10: -10...-1 dB
11...20: 1...10 dB
•‘s’ denotes the source, valid values are 1-8
•‘r’ denotes the SRS state, valid values are:
0: Off
1: Bass Boost
2: SRS 3D
3: Focus
4: WOW
5: SRS not available for this room
•‘z’ denotes the zone, valid values are:
0: not connected to a zone
1...32: zone ID
•‘l’ denotes the balance, valid values are:
0: balanced equally
1...10: 100% … 10% Left
11...20: 10% … 100% Right
MGSTr,v,bb,t,s,
r,z,l,p
(Cont.)
•‘p’ denotes the privacy status, valid values are:
0: Off
1: On
MRGSz,s,b8,b7,b6,
b5,b4,b3,b2,b1
Room Grouping Status, where:
•‘z’ is the group ID, valid values are:
0: no group ID – all rooms in selection are not in a grouping
1-32: group ID
•‘s’ is the source the rooms are currently associated with
•‘b8’…’b1’ is a binary room selection bitmap where all rooms to be grouped have a
binary 1 in the room position. The most significant bit in ‘b8’ is for room 64 and the
least significant bit in ‘b1’ is for room 1.
Note: If none of the bits are set in the room selection bitmap, then the room grouping
has been removed.
MGRSs,b8,b7,b6,
b5,b4,b3,b2,b1
Source Grouping Status, where:
•‘s’ is the source who the rooms are listening to
•‘b8’…’b1’ is a binary room selection bitmap where all rooms listening to ‘s’ have a
binary 1 in the room position. The most significant bit in ‘b8’ is for room 64 and the
least significant bit in ‘b1’ is for room 1
MFAVr,s,f Favorite Status, where:
•‘r’ is the room, (1-64)
•‘s’ is the source, valid values are 1-8
•‘f’ is the direct tuning string; it can be from 0 to 7 characters long and is translated as
specified in the ‘Send Source Direct Data’ command: Zero length data is returned if
the favorite is not set