Anderson Group Self-loading Bale Carrier TSR-3450 – Operator's Manual 59
7 Troubleshooting
7.1 Hydraulic Controls
Your self-loading bale carrier is equipped with hydraulic controls allowing you to manually operate
the carrier’s various components. These controls must be used for maintenance and diagnostic pur-
poses only.
Hydraulic controls must never be used if the car-
rier can start moving.
Before using the hydraulic controls, ensure that
no one will operate the controls at the same
time on the tractor.
The pressure in the hydraulic accumulator must
be maintained at 45 bar (650
psi). If the pressure descends below this
value, have the accumulator pressure adjusted
by a qualified technician.
If the hydraulic accumulator is not operating cor-
rectly or if it needs to be adjusted, use the ser-
vices of a qualified technician.
To Next Page
Loading...
Need help?
General
