13000-00162 iii
September 2005
For Safety
Always refer to the operation manual when working near locations
at which the alert mark, shown on the left, is attached. If operation
is performed without heeding the advice in the operation manual,
there is a risk of personal injury. In addition, the equipment
performance may be reduced.
Moreover, this alert mark is sometimes used with other marks and
descriptions indicating other dangers.
or
When supplying AC power to this equipment, connect the
accessory 3-pin power cord to a 3-pin grounded power outlet. If a
grounded 3-pin outlet is not available, use a conversion adapter
and ground the green wire, or connect the frame ground on the
rear panel of the equipment to ground. If power is supplied without
grounding the equipment, there is a risk of receiving a severe or
fatal electric shock.
The operator cannot repair this equipment. DO NOT attempt to
remove the equipment covers or to disassemble internal
components. Only qualified service technicians with knowledge of
electrical fire and shock hazards should service this equipment.
There are high-voltage parts in this equipment presenting a risk of
severe injury or fatal electric shock to untrained personnel. In
addition, there is a risk of damage to precision components.
If this equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment may
be impaired.
To Next Page
Loading...
Need help?
General
