ML248xA / ML249xA Common Procedures
5-18 13000-00162
September 2005
A Input is taken from sensor A.
B Input is taken from sensor B.
Single
Ext
Voltage
Take input from the rear panel BNC, “Input 2, Analog”.
A/B Sensor measurement A is divided by sensor measurement
B and displayed on the current channel.
B/A Sensor measurement B is divided by sensor measurement
A and displayed on the current channel.
A-B Sensor measurement B is subtracted from sensor
measurement A and displayed on the current channel.
Combined
B-A Sensor measurement A is subtracted from sensor
measurement B and displayed on the current channel.
4. Select the required input configuration from either the Sngl or Cmb menus.
5. Use the down arrow on the numerical keypad to select another item in the dialog, or
press the [Exit] hard key if no further settings are required.
To Next Page
Loading...
Need help?
General
