Front Panel Layout and Operation ML248xA / ML249xA
13000-00162 4-17
September 2005
Data Entry Procedure
Numeric Entry Example
The steps below serve as an example of how to enter a numeric value. Follow the steps
carefully until you become familiar with the procedure.
1. Press the Channel hard key followed by the Set Up soft key.
2. A user entry dialog opens with the “Mode” entry field already highlighted and set to
“Pulsed/Modulated”. The soft keys to the right of the dialog indicate that this is a
selection type entry field, and that the setting can be changed by pressing the soft
keys available. In this case, there are two choices Pulsed/Modulated and CW , and
as these are pressed, the entry in the “Mode” field changes accordingly. For the
purposes of this explanation, select Pulsed/Modulated. As described earlier in this
section, a green strip on the right of the soft button indicates the parameter that is
currently selected.
3. Press the down arrow on the numeric keypad to move the cursor down to
“Settling %”.
4. Press the center [Sel] key on the numeric keypad. The current setting in the
“Settling %” entry field is now replaced with a number of underscores. The number of
underscores indicates the number of digits that can be entered in this field.
To Next Page
Loading...
Need help?
General
