4-4 File Menu Chapter 4 — File Management
4-6 PN: 10580-00175 Rev. N MS272xB + MS8911B UG
4-4 File Menu
Key Sequence: File
Save Measurement As: This key will save the current setup with a user
defined file name. The default file name is changed using the Save submenu.
To change the default file name, press the Save Measurement submenu key
to open the Save dialog box. Enter the new measurement filename with the
letter keys. Refer to “Save Menu” on page 4-7. Press Enter to save the name
and return to the File menu. The Save Measurement As submenu key
displays the new entered name appended with _#1.spa. After a few seconds
the screen with return to File menu. Press the Save Measurement As key
again and the new file name will be used. Measurement files names have a
.spa extension.
Save Measurement: Press this submenu key to display the “Save Menu”
on page 4-7 and Save dialog box. Measurements can be saved to internal
memory or to a USB flash drive. The saved measurement can be named
using the text entry keys. By default, measurements are saved in a directory
named /user to internal memory. The save destination is set with the
“Save Location Menu” on page 4-8.
Save: Press this submenu key to display the “Save Menu” on page 4-7.
Measurements can be saved to internal memory or to a USB flash drive. The
saved setup, measurement, or JPEG file can be named by using the text
entry keys. By default, measurements are saved in a directory named /user to
internal memory. The save destination is set with the “Save Location Menu”
on page 4-8.
Save on Event (Spectrum Analyzer mode only): Press this submenu key to
display the “Save On Event Menu” on page 4-9.
Recall Measurement: Press this submenu key to display the “Recall Menu”
on page 4-10. This menu is for recalling measurements from internal memory
or a USB flash drive.
Recall: Press this submenu key to display the “Recall Menu” on page 4-10.
This menu is for recalling measurement or setup data from internal memory or
a USB flash drive.
Copy: Press this submenu key to display the “Copy Menu” on page 4-11.
This submenu is for copying files or folders from internal memory or a USB
flash drive.
Delete: Press this submenu key to display the “Delete Menu” on page 4-12
and a selection box that shows the setup and measurement names, the type
and the date and time that the information was saved. Use the rotary knob or
the Up/Down arrow keys to highlight the file that is to be deleted and press
the Delete submenu key, then Enter. Press the Esc key to cancel the
operation. Note that deleted files can not be recovered.
Figure 4-5. File Menu
File
Copy
Recall
Recall
Measurement
Recall
Save
On
Event
Save
Save Measurement As
FileName.spa
Save
Measurement
Delete
To Next Page
Loading...
Need help?
General
