Applent Instruments AT682 - 7.10 STATe Subsystem

7. SCPI Command Reference
41
For example
Tx> COMP:BEEP on
Query Syntax
COMParator:BEEP?
Query Response
{on,off}
For example
Tx> COMP:BEEP?
Rx> on
Constraints
none
:BEEP:SET
The :BEEP:SET command sets ng beep or gd beep.
Command Syntax
COMParator:BEEP:SET {ng,gd}
Parameters
{ng,gd}
For example
Tx> COMP:BEEP:SET ng
Query Syntax
COMParator:BEEP:SET?
Query Response
{ng,gd}
For example
Tx> COMP:BEEP:SET?
Rx> ng
Constraints
none
7.10 STATe Subsystem
The STATe subsystem sets instrument state to CHARG or DISCH.
Figure 7-6
STATe
Command Tree
Query Syntax
STATe?
Query Response
{charge,discharge,test}
where
charge: CHARGE state
discharge: DISCH state
test: TEST state
For example
Tx> STATe?
Rx> discharge
Constraints
none

NOTE:
All commands after state subsystem will be ignored.
STATe
:CHARage
:DISCharge