19
NOTE!
The warning tone that is emitted when switching the seeding shaft on/off can be deactivated as
described in chapter 8.10.
5.5 EMPTYING
This menu point is for practical emptying of the hopper (e.g. when finishing
work, changing seeds, changing the seeding shaft).
The motor is running at maximum speed (without fan).
Emptying can be stopped at any time by pressing the plus/minus, seeding shaft or fan buttons. Then the
display goes back to the Main menu.
TIP!
Before you start emptying, check whether you have removed the calibration cover and are using
it or the calibration slide. Check whether the calibration bag or a collection bucket is place
precisely under the outlet.
5.5.1 EMPTYING USING THE CALIBRATION BUTTON
If you have a calibration button installed on your implement and it is set to
YES in the Programming menu (see chapter 0), it can then be used to empty
the hopper. The seeding shaft rotates at maximum speed as long as the
calibration button is pressed.
5.6 OPERATING HOURS COUNTER
Total hours:
23.46 h_
Hours:
0.38 h_
Operating hours counter = running time of the seeding shaft.
Shows the total hours and the daily hours.
By pressing the OK button (press and hold for 5 seconds), the daily hours
can be reset to zero. The total hours cannot be reset to zero.
5.7 HECTARE COUNTER (SEEDED AREA)
Total area:
12.07 ha_
Area:
3.93 ha_
Shows the total seeded area in hectares.
The values are automatically set when the calibration test is performed. The
area that is seeded is only counted when the seeding shaft starts rotating.
By pressing the OK button (press and hold for 5 seconds), the area can be
reset to zero. The total area cannot be reset to zero.
To Next Page
Loading...
Need help?
General