APV 5.2 Operating Manual

28
8.3 SIGNAL WHEN SWITCHING THE SEEDING SHAFT ON/OFF
(WARNING TONE)
2. Signal when
switching the
seeding shaft on/off:
The acoustic warning tone when switching the seeding shaft on/off can be
activated or deactivated here.
Use the plus/minus buttons to select YES/NO.
8.4 GROUND WHEEL
3. Ground wheel
equipped:
In this menu point, you can select whether you are working with or without
a ground wheel.
Use the plus/minus buttons to select YES/NO.
8.5 WHEEL SENSOR
4. Speed
sensor on the
tractor wheel equip.:
Here, you can select whether you are working with the speed sensor on
the tractor or the feeler wheel.
Use the plus/minus buttons to select YES/NO.
8.6 DIN 9684 SIGNAL (7-PIN SIGNAL SOCKET)
Here, you can select whether you are using signals from the tractor and which ones.
Provided that they are equipped, 3 different signals are used:
 Linkage signal (not equipped on all tractors)
 Theoretical speed (from the gearbox)
 Actual speed (usually from the radar sensor)
TIP: If several speed signals are available, the (more accurate) actual speed signal is preferred.
5. DIN signal
"Cur. speed"
equipped:
Here, you can set whether an actual speed signal is available (PIN 1 on
the 7-pin signal socket).
Use the plus/minus buttons to select YES/NO.
6. DIN signal
"Theor. speed"
equipped:
Here, you can set whether a theoretical speed signal is available (PIN 2
on the 7-pin signal socket).
Use the plus/minus buttons to select YES/NO.
8.7 RADAR SENSOR
7. Radar sensor
equipped:
Here, you can select whether you are working with or without a radar
sensor (or GPSa).
Use the plus/minus buttons to select YES/NO.
8.8 LIFTING UNIT SENSOR
8. Linkage
equipped:
If you want to work with the linkage signals from the tractor or a linkage
sensor, please select:
Use the plus/minus buttons to select YES/NO/AUTO/2 sections.

APV 5.2 Specifications

General

Brand	APV
Model	5.2
Category	Control Unit
Language	English