To Next Page

To Previous Page

9.8 SPLITTER SENSOR MX FOR POWER SOCKET

Is required if you want to work with 2 sensors (e.g. the wheel sensor

and the linkage sensor).

Order number: 00410-2-153

Cable length: 1 m

Connection: 12-pin plug on the control box

Figure 15

Connection diagram:

12-pin plug for the

control box

Speed sensors

Linkage sensor yellow marking with the

label (Hubwerk/Linkage)

9.9 COMPLETE CABLE SET

For the power supply to the control box without a standard 3-pin

standard socket on the tractor, a retrofit kit is available as an

accessory. On the battery side, this 8 m cable is bolted directly on the

battery terminals. On the other side, a 3-pin standard socket is

installed.

Order number: 00410-2-022

Cable length: 8 m

Connection diagram:

Red (6 mm² cable) = 12 volt

Red (2.5 mm² cable) = Ignition plus

Black (6 mm² cable) = Earth

Figure 16

9.10 CALIBRATION BUTTON (CALIBRATION SWITCH)

The calibration button is installed directly in the cable harness of the

implement and is simply mounted on the implement with the

integrated magnets. This allows you to start the calibration test when

you are standing beside the implement, to calibrate for any length of

time, and also to empty the hopper. As soon as the calibration test

was started on the control box and you actuate the calibration button,

the seeding shaft starts rotating. The calibration procedure keeps

running until you let go of the calibration button again. The controller

then calculates the required spread rate, which then only has to be

weighed and entered in the menu.

Figure 17

APV 5.2 Operating Manual

Other manuals for APV 5.2