32
Installation: To fasten the radar sensor, please use the bolts,
nuts, and holding plate provided for this purpose in
the scope of delivery (see Figure 9)
9.4 ACCESSORIES KIT FOR INDUCTIVE WHEEL SENSOR MX
The wheel sensor measures the forward speed [km/h]. This is
displayed on the control box and the seed quantity is automatically
regulated by regulating the speed of the seeding shaft. As a result,
the desired seed quantity per hectare is always maintained, even if
the driven speed deviates slightly from the speed defined by the
calibration test.
The sensor can detect both the supplied magnets and any type of
metal (bolt heads, wheel bolts, etc.).
Order number: 00410-2-181
Connection: 12-pin plug on the control box
Settings: see chapter 8.5
Cable length: 5 m
CAUTION!
Do not hold the Neodym magnets close to your heart! If you have a pacemaker, it can cause
disturbances!
Installation position: the magnet is installed on the inside of the rim. The sensor must be fastened at a
distance of max. 5 mm from the magnets (or wheel bolts, nuts, etc.). When the
sensor is actuated, the LED on the rear lights up.
To Next Page
Loading...
Need help?
General