22
△
! Calibration value too
high!
The number of pulses during
calibration is too high.
When calibrating the speed,
reduce the number of
magnets on the wheel
sensor.
Install the sensor on the
shaft rotating more slowly.
△
! Calibration value too
low!
The number of pulses during
calibration is too low.
When calibrating the speed,
increase the number of
magnets on the wheel
sensor.
Check the sensor.
Check the cabling.
Check the settings for the
speed sensor.
△
! Seeding shaft speed too
low!
The seeding shaft speed during
the calibration test is too low.
Use a seeding shaft with
smaller/finer or fewer seed
wheels.
Increase the forward speed.
Increase the spread rate.
During field operation, the PS is
equipped with several
implement extension cables,
and it may not be possible to
achieve the higher seeding
shafts speeds that may be
required.
Reduce the number of
implement extension cables
to a minimum.
Check the battery and plug
connections.
Use a seeding shaft with
larger/coarser seed wheels.
△
! Seeding shaft speed too
high!
The seeding shaft speed during
the calibration test is too high.
Use a seeding shaft with
larger/coarser or multiple
seed wheels.
Reduce the forward speed.
Reduce the spread rate.
The pump is running at its
maximum and can no longer
reach the spread rate.
The flow sensor connection
(brown, black) is not or not
properly connected.
Reduce the speed.
Reduce the spread rate.
Use larger nozzles.
Install more outlets.
Check the cabling.
△
! Calibration time too
short!
The calibration time is too short.
To achieve sufficient
accuracy, the calibration
button must be pressed and
held for at least 20 seconds.
△
! Vehicle speed too high!
The forward speed is too high
and the seeding shaft can no
longer readjust.
Reduce the forward speed.
Use a coarser seeding shaft.
△
! Vehicle speed too low!
The forward speed is too low
and the seeding shaft can no
longer readjust.
Increase the forward speed.
Use a finer seeding shaft.
To Next Page
Loading...
Need help?
General