MAINTENANCE AND CLEANING
Elevating the FUV - Front
To ensure that the FUV stays stable when elevated, only
lift one front wheel at a time, as described below.
1.
Position the floor jack under either the Front-Left or
Front-Right Lift Point (depending on which side will
be elevated).
2. Elevate the nose just enough to lift the wheel off the
ground, and place a jack stand under either the
Front-Left or Front-Right Jack Stand Point, on the
side that is elevated.
NOTE
Elevate the FUV only until the tire just clears the surface
and enough clearance is obtained to remove and replace
the wheel. Minimum lift provides maximum stability.
Elevating the FUV higher than necessary can make it
less stable. It could slip off the jack and hurt someone
near it. Elevate the FUV only enough to remove the
wheel.
3. Carefully lower the floor jack to allow the FUV to
rest on the Jack Stand.
4. As you lower the floor jack, carefully observe the
jack stand, and ensure that it is level and stable.
FUV Owner's Guide - 123
To Next Page
Loading...
