FUV Owner's Guide - 124
5. Once the front is resting on the jack stand, the floor
jack can be removed.
Elevating the FUV - Rear
1. Chock both front wheels.
2. Position the floor jack under the Rear Lift Point.
3. Raise the rear just enough to lift the rear wheel off
the ground, and place two jack stands at the Jack
Stand Points indicated above.
NOTE
Elevate the FUV only until the tire just clears the surface
and enough clearance is obtained to remove and replace
the wheel.
Elevating the FUV higher than necessary can make it
less stable. It could slip off the jack and hurt someone
near it. Elevate the FUV only enough to remove the
wheel.
4. Carefully lower the floor jack to allow the FUV to
rest on the Jack Stands.
5. As you lower the floor jack, carefully observe the
jack stands, and ensure that they are level and
stable.
MAINTENANCE AND CLEANING
To Next Page
Loading...
