Arkel ArLine User Manual V1.24
16. Arkel ArLine Parallel Installation
To use Arkel ArLine devices independently from ARKEL elevator controllers, the parallel installation parameters of Arkel
Arline-M must be set. Some features can be programmed using programmable inputs and outputs in the parallel installation. To
use the SMS alarm filter with programmable input, follow the steps below (the same settings can also be done via Cloud or
AREM).
Send an SMS to the SIM card installed in the device in the following format.
After setting the parameters correctly, you will receive an SMS response as shown below. SystemType: Parallel AlarmFiltering:
Active IN1: AFTL Once you ensure that these three parameters are correct, the COP module will apply the alarm filter when
IN1 input is energized.
Other features can be programmed in the same way.
17. Intercom
As per EN 81-20 standard;
• No direct voice communication between in the car and emergency rescue place is not possible (Eg. in hydraulic lifts)
• Or where the movement distance of the lift exceeds 30 m,
• A two-way communication system (Intercom) should be installed between the inside the car and the emergency rescue
area (Machine room/control panel).
An Arkel ArLine-S-INT unit added to the Arkel ArLine system can be used to provide the intercom specification described in
EN 81-20. In addition, in the Arkel ArLine system, two-way communication can be made between all speech units.
The ID of the Arkel ArLine-S-INT unit to be used for intercom in the machine room must be set to "04" with the dip-switch (See
section Arkel ArLine-S-TP / Arkel ArLine-S-INT Dip-switch Settings).
The Arkel ArLine-S-TP and Arkel ArLine-S-INT units are equipped with an intercom button, which is indicated by a white
ICOM.
The priority between alarm and intercom work is as follows:
• Intercom communication cannot be performed while the alarm service is active with the rescue service.
• If an alarm is triggered during intercom communication, the intercom is deactivated. Intercom communication is
restored when the alarm communication is switched off.
• Intercom calls can be made when there is an alarm condition that has not yet been terminated, but only when there is
no alarm voice communication with the rescue service.
Intercom operation can occur in two different ways when there is no alarm communication priority:
1) Between outdoor units and car unit:
• When the intercom button on the Arkel ArLine-S-INT or any Arkel ArLine-S-TP unit is held down for less than 3
seconds while no intercom communication is available, communication is initiated between that unit and the in-car
Arkel ArLine-S-COP unit.
• The Arkel ArLine-S-INT / TP units use the push-to-talk and listen method. The Arkel ArLine-S-COP talk is active
unless the Arkel ArLine-S-INT / TP unit is used to talk.
• Communication time is 3 minutes. Each time it is pressed, the intercom button will be set back to 3 minutes. If the
button is pressed 2 times within 1 second, the communication is ended.
2) Between outdoor units:
• When there is no intercom communication, pressing and holding the intercom button on the Arkel ArLine-S-INT or
any Arkel ArLine-S-TP unit for longer than 3 seconds will sound an audible signal on other Arkel ArLine-S-INT / TP
units. Communication is initiated with the intercom button on the unit. Other units cannot initiate communication until
this communication is terminated.
To Next Page
Loading...