Chapter 10:
STANDARD 365-095-33577 Revision x.1 IPC4100 Release 1.0 Installation and Operation Guide
75
Table 24. Purchase / Poll Status Fields
Field Description
Purchases Balance This value reflects the number of purchases that
can be made. It is configured by the headend.
Unsent The number of purchases in the RCM remaining
to be polled. It can be an integer from 0 to 63.
Unack The number of reports that have not been
acknowledged by the controller. It is an integer.
Last Seq Num The last acknowledged sequence number of a
purchase sent by the controller. It is a 16-bit,
unsigned hexadecimal number.
Last RB Time The last time the Product attempted to report
back purchases to the controller, in GPS seconds.
IPPV Status
Credit Balance
If IPPV is enabled, the IPPV status indicator is ON.
If IPPV is disabled, the IPPV status indicator is
OFF.
Credit available for IPPV Purchase.
Last Poll Status:
Prep Command "Last Prepare for Poll Command" sequence
number and time of the last prepare for poll
request command that was sent by the controller.
Note that each requesting process maintains an
independent sequence of poll requests to
uniquely identify the poll responses.
Prep ACK "Last Prepare for Poll Acknowledge" sequence
number and time of the last Report Purchase
request sent by the controller.
Poll Request Sequence number and time of the last send poll
buffer command that was sent by the controller.
Poll Acknowledge Sequence number and time of the last Poll
Acknowledge message sent by the controller.
To Next Page
Loading...
