5.3.1 The Display
The display is the central hub for all the information needed while using SPARK (i.e.
Project name, parameter value changes, etc.).
5.3.2 The Sequencer zone
The Sequencer zone is divided into several zones:
5.3.2.1 The Sequencer Step pads
The 16 Sequencer Step pads are numbered from 1 to 16 or from 17 to 32 depending on
the length of the pattern and the timing value assigned to each step.
These pads allow you to edit your pattern by triggering note-on messages on your
instrument track. Patterns have a maximum number of 64 steps. If your pattern has
more than 16 steps, use the << or >> buttons to navigate to the previous or next page.
If you click on the >> next page button, you will see the numbering on the pads switch
from 1-16 to 17-32 for the second page, and so on.
You may choose to follow the cursor as it advances on the step pads (the pages will
change automatically) by right clicking on the >> button. A contextual menu will appear
allowing you to check or uncheck the “follow current step” option. If this option is
activated, both << and >> buttons will be lit. If the follow option is deactivated, the
buttons will not be lit up.
The step resolution is a sixteenth note by default. You can change the resolution in the
pattern panel (see section 5.4.1).
5.3.2.2 The Shuffle Knob
To Next Page
Loading...