EasyManuals Logo

ASCOM d41 User Manual

ASCOM d41
55 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #47 background imageLoading...
Page #47 background image
TD 92582GB
2009-12-15/ Ver. C
User Manual
Ascom d41 DECT Handset
43
Operational Problems
Error or Warning Messages
Fault Probable cause Action or comment
No display The battery level is low or the
handset is defective.
Charge the battery or contact
system administrator.
No ringing The sound off icon is on, or ringer
volume set to silent, or the
handset is defective.
Long press the Sound off key,
or increase volume, or contact
system administrator.
Display shows Probable cause Action or comment
No access The network is in range, but no
access rights.
Switch handset off and then
switch it on again or contact
system administrator.
No System. The
handset beeps once a
minute (during max 30
minutes) with a low
tone followed by a
high tone (if enabled,
the vibrator also
follows the beeps).
The handset is out of coverage or
handset is defective.
Stop the beep with the Sound
off key and go into range.
Note: When re-entering the
coverage area it can take a
couple of minutes before the
handset automatically has
registered into the system.
or
contact system administrator.
SERVICE NEEDED
Parameters corrupt
Note: This display
message is only shown
in English.
Faulty handset. Select the reset option on the
middle soft key and upgrade
the handset’s software to
version 3.0.0 or greater. If this
is not available or the problem
persists send the handset for
service.
SERVICE NEEDED
Invalid IPDI
Note: This display
message is only shown
in English.
Easy replacement procedure not
followed correctly or failure
during easy replacement
procedure.
Send the handset for service.
Enter PIN code The handset’s lock is activated. Enter the required PIN code. If
PIN code lost enter new via
PDM or do a factory reset via
PDM.
Battery low, charge
now
The battery level is low. Charge or replace the battery.
Phonebook is not
available at the
moment.
The phonebook does not
respond, not available at the
moment.
Try again later or if fault
persists do a factory reset via
admin menu or PDM.
Voice mail number not
defined
There is no Voice mail number
defined in the handset.
Define a Voice mail number via
PDM.

Table of Contents

Other manuals for ASCOM d41

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ASCOM d41 and is the answer not in the manual?

ASCOM d41 Specifications

General IconGeneral
TypeDECT telephone
Answering machineNo
Mounting type-
Product colorGray
SpeakerphoneYes
Phonebook capacity500 entries
Languages supportCZE, DAN, DEU, DUT, ENG, ESP, FIN, FRE, GRE, HUN, ITA, NOR, POL, POR, RUS, SLK, SWE, TUR
Standby time180 h
Battery recharge time4 h
Storage temperature (T-T)-20 - 60 °C
Operating temperature (T-T)0 - 40 °C
Number of handsets included1
Weight and Dimensions IconWeight and Dimensions
Depth24 mm
Width53 mm
Height133 mm

Related product manuals