SAFETY
7 AU103170 H5B
FAILURE IN OPERATION
• In the event of poor performance or machine failure,
stop the machine immediately and report the matter.
Take measures to prevent further use until the
malfunction is corrected (Place a DO NOT OPERATE
tag on the control panel, remove the key, turn off all
power sources, etc.) Before working on any hydraulic
or electrical circuits, refer to the maintenance sections
in this manual.
• Support or lower all attachments to the ground before
leaving or servicing the vehicle.
MACHINE OPERATION
• Check all controls in a clear area and make sure the
machine is operating correctly.
•DO NOT let other persons ride on the machine. Other
persons can fall or will cause an accident.
• Dust, fog, smoke, snow, etc., may decrease your vision
and cause an accident. Stop the machine or decrease
the speed until you can see everything around you in
the work area.
• Contact with high voltage power lines, underground
cables, etc., can cause serious injury or death from
electrocution.
• Before you drive or operate in an area with high
voltage lines or cables, contact your utility companies
or one of the Digging Hot Line numbers. You MUST
HAVE THE POWER DISCONNECTED OR KEEP A
SAFE WORKING DISTANCE from the lines or
cables. You must know the safe working distance from
the high voltage power equipment and must know any
federal, state/provincial or local safety codes or
regulations that apply to the job site.
• Electrical cables, gas pipes, water pipes or other
underground objects can cause injury or death. Learn
the location of underground hazards before you
operate your machine in a new area.
• If this machine turns over, you can be injured or killed.
You must make a judgment if weather, road or earth
conditions will permit safe operation on a hill, ramp or
rough ground.
• Operate the machine controls from the operators seat
only.
• Stay away from hazardous areas such as ditches,
overhangs, etc. Walk around the work area before you
start and look for hazards.
• Be alert and always know the locations of all workers in
your area. Keep all other persons completely away
from your machine. Injury or death can result if you do
not follow these instructions.
• If your view of the work area is not clear, always have
a signal person direct your movement. Know and
understand each signal from the signal person before
you start. If your visibility is reduced, install a guard rail
and warning signs to keep other persons away.
•DO NOT operate this machine while under the
influence of alcohol or drugs.
• NEVER allow anyone in the trench while digging.
• NEVER allow anyone to stand in the vicinity of the
trench while operating the trencher or backfill blade.
Stop the trencher and ground drive if anyone comes
close to the trencher or machine.
PARKING THE MACHINE
• When you park the machine, select level ground
whenever possible. If you must park on a slope or
incline, position the machine at right angles to the
slope.
• When you park the machine and before you leave the
operators area, always support or lower all
attachments to the ground, apply the parking brake,
stop the engine and remove the key.
• Follow the instructions in this manual for parking the
machine.
• Always face the machine and use the hand rails and
steps when getting off. Do not rush and do not jump
from the machine.
CAST DUCTILE IRON
• Before you weld, cut or drill holes in a part on this
machine, make sure the part is not cast ductile iron.
See your dealer if you do not know if a part is cast
ductile iron.
• Unauthorized modifications to cast ductile iron parts
can cause injury or death. Welding, cutting or drilling
can cause cast ductile iron to break. Do not weld, cut
or drill to repair or to attach items to cast ductile iron
parts on this machine.
WARNING:
Shut off engine and remove key
before performing any maintenance or repair
work.
To Next Page
Loading...
Need help?
General
