Chapter 4 Digital Output Settings (DIGITAL OUTPUT)
72
*1 About the PW_SAVE setting
When PW_SAVE is set, the VG876 and VG-879 execute the following processing.
<PW_SAVE=ON>
Writes “0x02” to DPCD 0x00600 Bits1:0 (SET_POWER) of the connected sync device and sets Main Link and AUXCH to
the power down state.
<PW_SAVE=OFF>
Wakes up Main Link and AUXCH and writes “0x01” to DPCD 0x00600 Bits1:0 (SET_POWER) of the connected sync
device. At this time, Link Training is not executed. Press “LT” to execute Link Training.
*2 About the AUD_MUTE setting
When Audio Mute = ON is set, operation differs between the VM-1876-M1 and VM-1876A-M1.
VM-1876-M1: The output level becomes 0 (MUTE state) in the state when the audio packet has been transmitted.
AudioMute_Flag (VB-ID bit4) is set to 1.
VM-1876A-M1: The audio packet is not transmitted. (Same state as Audio Output = OFF)
AudioMute_Flag (VB-ID bit4) is set to 1.
*3 About the EDIT settings
If a setting item (e.g., Link Rate) in the EDIT menu is changed, the setting is also reflected for output ports other than the
specified output port (analysis port).
To Next Page
Loading...
