Atal AT 505 - Installation of Drivers for the Receiver

Chap. III - Remote control
Gas-manual-en.docx — 44 —
2.3.1 INSTALLATION OF DRIVERS FOR THE RECEIVER
After you have clicked on the “Finish” button to complete the Remote control installation (see Fig. 76), it is
necessary to install the drivers for the Remote control receiver.
At the start of the installation wizard (see Fig. 83) a search for older (invalid) drivers takes place (see Fig. 84).
The following series of figures was taken from the installation wizard for Windows XP. The wizard for Windows
Vista is similar:
Fig.
83 – Start of the installation of RC receiver drivers
Fig.
84 – Search for older (invalid) drivers
a) If old drivers are detected, information about their presence will be displayed (see Fig. ) together with
a suggestion for their removal. It is recommended that you remove the old drivers.
Fig.
85 – The result of a search for old drivers – it is recommended to
uninstall them (Yes)
Fig.
86 – A warning from Windows XP is displayed (for further details
see the Note below)
The driver installation ensues. These will be used during the new hardware wizard which runs after the connection
of the RC receiver to a free USB port. Installation ensures that the installation CD will not be necessary again.
Warning:
If the old drivers are not removed, the new drivers will not be installed and correct operation of the RC receiver
cannot be guaranteed.
Note to Fig. 86:
A warning from Windows XP informs that the new driver is not certified by Microsoft. This notification can be
displayed in the process of installation several times and it is possible to ignore it without any concerns!