Chap. III - Remote control
Gas-manual-en.docx — 45 —
When the installation of the new drivers is complete, a notification is displayed recommending that the system is
restarted (see Fig. ). It is recommended to perform this restart.
b) If up-to-date drivers are detected, the information about their presence will be displayed (see Fig. 87)
and the RC installation will be complete.
Fig. 87 – The result of a search for old drivers (in this case the
drivers are up-to-date
Fig. 88 – A system recommendation for restarting– it is
recommended to perform the restart (Yes)
2.3.2 RC RECEIVER FINAL INSTALLATION
1. Installation can be initiated after successful RC installation.
2. Connect the RC receiver to the PC (insert it into a free USB port)
3. The device should be detected, see Fig. 89.
4. The hardware installation is straightforward and is guided by the installation wizard on the PC screen.
Fig. 89 – Info tip about the successful installation of the device (Windows XP)
Note:
The language of the Wizard corresponds to your language version of Windows.
The following series of figures was taken from the installation wizard for the Windows XP operating system. The
wizard for Windows Vista is similar:
To Next Page
Loading...