Keypad Features and Operation
Digital Life User Manual | Page 12 of 62 ATT-UM-V1.1-201303
The system will proceed with the Arming STAY/AWAY sequence.
You should exit through the designated entry/exit door(s) before the exit delay
timer interval expires. After the exit delay timer interval expires, the system is in
the Armed-STAY or Armed-AWAY mode. The ARMED (Red) LIGHT is
illuminated and the LCD displays “Armed - STAY” or “Armed –AWAY”. Initially
the keypad beeps slowly during the exit delay timer interval and then chirps fast
for the last ten (10) seconds.
NOTE: You may disarm the system during the exit delay timer interval by
entering your four (4) digit Alarm Panel PIN.
Disarming the System – Entry Delay
When the system is in the Armed-AWAY or Armed-STAY mode and you enter the
residence through a designated entry/exit door, the system generates an entry delay
timer interval and the keypad begins beeping. The entry delay timer interval allows
you to get to the keypad and enter your Alarm Panel PIN before the system sounds
an alarm. Initially the keypad beeps slowly during the entry delay timer interval and
then chirps fast for the last ten (10) seconds and the LCD displays “Alarm – Enter
PIN to Cancel,” as shown:
To Next Page
Loading...
Need help?
General
