Keypad Features and Operation
Digital Life User Manual | Page 19 of 62 ATT-UM-V1.1-201303
To replace the batteries:
1. Make sure that the system is disarmed before replacing the batteries.
2. Slide the keypad upward to remove the keypad from the base.
3. Turn the keypad to the backside.
4. Remove all existing batteries and dispose of them properly.
5. Insert four (4) AA alkaline batteries (Duracell
®
MN1500, Energizer
®
EN91, or
Panasonic
®
LR6XWA) batteries.
NOTE: Observe the polarity of the batteries for correct battery installation.
6. Restore the keypad to its base.
Keypad and Siren Sounds
Your Keypad (SW-ATT-PAD2W) and Siren (SW-ATT-SRN) will make different audible
sounds based on the actual event that is taking place, such as arming, disarming,
alarming or emergency events.
Feature Device(s) Sound Operation
Armed Away Keypad
(SW-ATT-PAD2W)
Two (2) chirps Two chirps sounded at the
end of Exit Delay Timer
Interval
Armed Stay Keypad
(SW-ATT-PAD2W)
Two (2) chirps Two chirps sounded at the
end of Exit Delay Timer
Interval
Cancel Alarm Keypad
(SW-ATT-PAD2W)
Two (2) long two
(2) second beeps
Two long beeps are
sounded when you enter
your Alarm Panel PIN after
an alarm has been sent to
Digital Life Central
Monitoring Center
To Next Page
Loading...
Need help?
General
