915MHz Repeater Features and Operation
Digital Life User Manual | Page 43 of 62 ATT-UM-V1.1-201303
Replacing the 915MHz Repeater (SW-ATT-RPTR9) Batteries
You can replace the batteries by opening the battery compartment located on the rear of
the unit. You must first remove the retaining screw that is located at the top of the
915MHz Repeater (SW-ATT-RPTR9) that secures the 915 MHz repeater to the AC
outlet and then remove the unit from the AC outlet.
NOTE: Be sure to observe the polarity of the batteries during battery replacement
After you have installed new batteries, plug the 915MHz Repeater (SW-ATT-RPTR9)
back into the lower socket of the AC outlet. Then replace the retaining screw in the
plastic tab at the top of the repeater and secure the 915 MHz repeater to the AC outlet.
To Next Page
Loading...
Need help?
General
