Recessed Door/Window Sensor Features and
Operation
Digital Life User Manual | Page 37 of 62 ATT-UM-V1.1-201303
The recessed door/window sensor requires one (1) 3V CR2 Lithium Battery CR2 Lithium
(Panasonic
®
CR-2, GPI
®
GPCR2).
Reinsert the transmitter assembly into its housing. Replace the cap for the transmitter
assembly. Insert the transmitter assembly into the door or window jam and install the
screws for securing the transmitter (if they were used in the initial installation process).
NOTE: Properly slide the unit into the channel for proper fit.
Testing the Recessed Door/Window Sensor (SW-ATT-RDW)
See the Test Your System section for instructions concerning testing your Recessed
Door/Window Sensor(s) (SW-ATT-RDW).
To Next Page
Loading...