12
Getting started
Battery charging
Once you have installed the battery, the screen indicates the battery status
(see the following table). If necessary, place the handset in the charger to
charge the battery. For best performance, keep the handset in the charger
when not in use. The battery is fully charged after 16 hours of continuous
charging. See the table on page 161 for battery operating times.
If the screen shows Low battery, you need to charge the battery without
interruption for at least 25 minutes to give the handset enough charge to use
the telephone for a short time. The following table summarizes the battery
charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank or shows
Place in charger.
The battery has no or very
little charge. The handset
cannot be used.
Charge without interruption
until the screen shows
Low battery or HANDSET X
(at least 25 minutes).
The screen shows
Low battery and flashes.
Battery has enough charge to
be used for a short time.
Charge without interruption
until the screen shows
HANDSET X (at least 25
minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery charged,
place it in the charger when
not in use.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps
every minute.
SET DATE
--/--/--
MM/DD/YY
SET
SET TIME
--:-- --
SET
After you install your telephone, the handset will prompt
you to set the date and time. For instructions, see
Set date/time on page 37. To skip setting the date and
time, press OFF/CLEAR.
To Next Page
Loading...
Need help?
General
