47
Telephone settings
Telephone base settings
Set date/time
The answering system announces the day and time of each message prior
to playing it. If you subscribe to caller ID service, the day, month and time
are set automatically with each incoming call. Before using the answering
system, set the date and time as follows.
To set the date and time manually:
Press the MENU softkey on the telephone base in idle
mode to enter the main menu.
Press DIR, CID, /DELETE or
/REC
to highlight
Settings, then press the SELECT softkey.
Press DIR, CID, /DELETE or
/REC
to highlight
Set date/time, then press the SELECT softkey.
Press the SELECT softkey to select Date/time.
Press DIR, CID, /DELETE or
/REC
to select the
month and then press the SET softkey to confirm, or
enter the correct number using the dialing keys.
Press DIR, CID, /DELETE or
/REC
to select the
day and then press the SET softkey to confirm, or
enter the correct number using the dialing keys.
Press DIR, CID, /DELETE or
/REC
to select the
year or enter the correct number using the dialing
keys, then press the SET softkey.
Press DIR, CID, /DELETE or
/REC
to select the hour and then press
the SET softkey to confirm, or enter the correct number using the
dialing keys.
Press DIR, CID, /DELETE or
/REC
to select the minute and then
press the SET softkey to confirm, or enter the correct number using the
dialing keys.
Press DIR, CID, /DELETE or
/REC
to choose AM or PM, then press
the SET
softkey to confirm. You hear a confirmation tone.
NOTE: If the clock is not set when a message is recorded, the system announces, “Time
and day not set,” before the message is played.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
SETTINGS
Display alerts
Key tone
Set date/time
SELECT
SET DATE/TIME
Date/time
CID time sync
SELECT
SET DATE
01/01/09
MM/DD/YY
SET
SET TIME
06:08 PM
SET
To Next Page
Loading...
