AT&T TL86109 - Save a Redial Entry to the Directory

81
Telephone operation
Redial
To dial a redial entry of the telephone base:
Lift the corded handset, or press 1 LINE or
2 LINE. Then, p ress REDIAL to enter the redial list.
Press DIR, CID, /DELETE or /REC to
browse and then press the DIAL softkey to dial
the number displayed.
You can also select a redial entry before dialing.
Press REDIAL in idle mode.
Press DIR, CID, /DELETE or /REC to
browse until the desired number displays. The telephone base beeps twice
at the end of the list.
Press 1 LINE or 2 LINE to use the corresponding line, or press
CELLULAR to use the cell line.
NOTE: You may also lift the corded handset or press SPEAKER to dial a redial entry.
The default line for the corded handset and speakerphone are determined by the line
preference setting. To change the setting, please see page 43.
Save a redial entry to the directory
Using a cordless handset:
Press REDIAL/PAUSE in idle mode.
Press or to browse until the desired number displays.
Press the SAVE softkey.
The handset displays ENTER NUMBER. Use the dialing keys to edit the
number, if necessary.
Press OFF/CLEAR to erase a digit.
Press to move the cursor to the right or to the left.
Press and hold REDIAL/PAUSE to insert a dialing pause (a p appears).
Press the NEXT softkey.
The handset displays SELECT TYPES. Press or to select one of the
following types:
Home
Cell
Work
Other
Press the NEXT softkey. The handset displays ENTER NAME. Use the
dialing keys (page 95) to enter a name.
Press OFF/CLEAR to erase a character.
Press to move the cursor to the right or to the left.
Press the SAVE softkey to confirm and you hear a confirmation tone.
1.
2.
1.
2.
3.
1.
2.
3.
4.
•
•
•
5.
6.
•
•
•
•
7.
•
•
8.