64
Telephone settings
Answering system settings
Message alert tone
When the message alert tone is turned on, the telephone base beeps every
10 seconds to alert you of new messages. The tone stops when all new
messages have been reviewed. The default message alert setting is off.
To set the message alert tone on or off:
Using a cordless handset:
Press the MENU softkey on the handset in idle mode to
enter the main menu.
Press or to scroll to ANSWERING SYS, then press
the SELECT softkey.
Press or to choose Mailbox 1 or Mailbox 2, then
press the SELECT softkey.
Press or to highlight Ans sys setup, then press the
SELECT softkey.
Press or to highlight Msg alert tone, then press the
SELECT softkey.
Press or to choose On or Off.
Press the SET softkey to confirm. You hear a
confirmation tone.
Using the telephone base:
Press the MENU softkey on the telephone base in idle
mode to enter the main menu.
Press DIR, CID, /DELETE or
/REC
to highlight
Answering sys, then press the SELECT softkey.
Press DIR, CID, /DELETE or
/REC
to choose
Mailbox 1 or Mailbox 2, then press the SELECT softkey.
Press DIR, CID, /DELETE or
/REC
to highlight
Ans sys setup, then press the SELECT softkey.
Press DIR, CID, /DELETE or
/REC
to highlight
Msg alert tone, then press the SELECT softkey.
Press DIR, CID, /DELETE or
/REC
to choose On
or Off.
Press the SET softkey to confirm. You hear a
confirmation tone.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
6.
7.
ANSWERING SYS
Mailbox 1
Mailbox 2
BACK SELECT
MSG ALERT TONE
On
Off
BACK SET
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
BACK SELECT
MAILBOX 1
Record memo
Answer On/Off
Ans sys setup
BACK SELECT
ANSWERING SYS
Mailbox 1
Mailbox 2
SELECT
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
SELECT
MAILBOX 1
Record memo
Answer On/Off
Ans sys setup
SELECT
MSG ALERT TONE
On
Off
RECORD SET
To Next Page
Loading...
