AT&T TL86109 - Redial; Review the Redial List; Dial a Redial Entry

80
Telephone operation
Redial
Each handset and the telephone base stores the last 20 dialed numbers (up
to 30 digits each) on the redial list. The redial entries of each handset and
the telephone base are independent.
Review the redial list
To review the redial list of a cordless handset:
Press REDIAL/PAUSE in idle mode.
Press or to browse. The handset beeps twice
at the end of the list.
Press OFF/CLEAR to exit.
To review the redial list of the telephone base:
Press REDIAL in idle mode.
Press DIR, CID, /DELETE or /REC to browse.
The telephone base beeps twice at the end of the list.
Press CANCEL to exit.
Dial a redial entry
To dial a redial entry of a cordless handset:
Press 1 LINE/FLASH or 2 LINE/FLASH to use the corresponding line or
CELL to use the cell line. Then, press REDIAL/PAUSE to enter the
redial list.
Press or to browse until the desired number displays. The handset
beeps twice at the end of the list.
Press the DIAL softkey to dial the number displayed.
You can also select a redial entry before dialing.
Press REDIAL/PAUSE in idle mode.
Press or to browse until the desired number displays. The handset
beeps twice at the end of the list.
Press 1 LINE/FLASH or 2 LINE/FLASH to use the corresponding line or
CELL to use the cell line.
NOTE: You may also press /SPEAKER to dial a redial entry. The default line for the
speakerphone is determined by the line preference setting. To change the setting, see
page 33.
1.
2.
1.
2.
1.
2.
3.
1.
2.
3.