ACTA 4000 User Guide Programming ACTA
9836 4171 01 2008-12 49 (136)
Setting up your non-Atlas Copco memory type transducer
By selecting Shunt calibration in the Conf>Diagnostics menu or by connecting a new transducer, a
transducer database selection dialog box is displayed, see figure below. This dialog box consists of a list
of 10 positions.
Each position is capable of holding a set of
transducer data. Displayed for each position is:
Number
Comment
Serial number
To select a position, use the up and down arrows to navigate in the list or use the number keys. Press
ENTER when ready. The Del key removes the transducer from the list. To edit a position, press Edit. A
dialog box then pops up with the following contents:
To Next Page
Loading...
