ACTA 4000 User Guide Programming ACTA
9836 4171 01 2008-12 63 (136)
3 Torque LCLx
Here is where you define the lower control limit for each subgroup x-bar
value.
4 Torque UCLx
Here is where you define the upper control limit for each subgroup x-bar
value. See the Statistics chapter for more information.
5 Torque LCLr
Here is where you define the lower control limit for each subgroup range
values. See the Statistics chapter for more information.
6 Torque UCLr
Here is where you define the upper control limit for each subgroup range
value. See the Statistics chapter for more information.
7 Torque CM >
Here is where you define the minimum allowed CM (machine capability
index) value. Values below this minimum value will initiate statistical
alarms.
8 Torque CMK >
Here is where you define the minimum allowed CMK (modified machine
capability index) value. Values below this minimum value will initiate
statistical alarms.
9 Torque CAM >
Here is where you define the minimum allowed CAM value. Values
below this minimum value will initiate statistical alarms.
0 Torque mean diff <
Here is where you define the maximum allowed mean difference in per
cent between torque and controller torque.
When all parameters have been set according to your preference, highlight
OK and press Enter or simply
press the
OK button on the keypad. Torque setup is now completed and saved and the pop-up dialog box
disappears.
Angle
In this dialog you define the statistical measurement criteria’s for angle limits that ACTA shall use for the
statistical calculation for this tool. Parameters to set are:
1 Angle min.
Here is where you define the minimum angle limit for each measurement.
2 Angle max.
Here is where you define the maximum angle limit for each measurement.
3 Angle LCLx
Here is where you define the lower control limit for each subgroup x-bar
value.
4 Angle UCLx
Here is where you define the upper control limit for each subgroup x-bar
value.
5 Angle LCLr
Here is where you define the lower control limit for each subgroup range
values.
6 Angle UCLr
Here is where you define the upper control limit for each subgroup range
To Next Page
Loading...
