- 15 -
2.2 Markings
Markings provide instructions and information. They
also warn of hazards. For convenience and safety,
keep all markings in legible condition, replacing them
when damaged or missing. Replacement markings are
available from the factory.
A brief description of all markings provided on the
ESS is given hereafter. The precise location of all
markings can be found in the parts manual of this
ESS.
Indicates that an electric voltage,
dangerous to life, is present. Never
touch the electric terminals during
operation.
Indicates that these parts can become
very hot during operation (e.g.
engine, cooler, etc.). Always make
sure that these parts are cooled down
before touching them.
Indicates the forklift slots.
Indicates that the machine should not
be cleaned with high pressurised
water.
Indicates that the unit may
start automatically and
that the instruction book
has to be consulted prior
to use.
Read the instruction
manual before using the
lifting eye.
Indicates the location of the battery.
Avoid water ingress as this could
cause short circuits.
Indicates the earthing connections on
the ESS.
Indicates the roof guides.
Warning!
Indicates that the unit contains a
chargeable battery.
Indicates that the unit contains
lithium cells or batteries.
Indicates that the unit may start
automatically and that the instruction
book has to be consulter prior to use.
Indicates Arc flash and shock
hazard. Follow all requirements
in NFPA 70E for safe work
practices and for Personal
Protective Equipment.
Warning and information label
on Arc flash hazard and
appropriate PPE requirement.
00_00_ZBP45_EN.book Page 15 Monday, October 19, 2020 9:52 AM
To Next Page
Loading...