EasyManua.ls Logo

Atlas Copco ZBP45 - 1.6 Tool Applications Safety; 1.7 Battery Safety Precautions

Atlas Copco ZBP45
106 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 12 -
16 When using cartridge type breathing filter equip-
ment, ascertain that the correct type of cartridge is
used and that its useful service life is not surpassed.
17 Make sure that solvents and other substances likely
to pollute the environment are properly disposed of.
18 Before clearing the ESS for use after maintenance
or overhaul, submit it to a test run, check that the
AC power performance is correct and that the
control and shutdown devices function correctly.
All precautions regarding batteries: see chapter 1.7.
1.6 Tool applications safety
Apply the proper tool for each job. With the knowledge
of correct tool use and knowing the limitations of tools,
along with some common sense, many accidents can be
prevented.
Special service tools are available for specific jobs and
should be used when recommended. The use of these
tools will save time and prevent damage to parts.
1.7 Battery safety precautions
While working on the Li-ion Battery wear protective
eyeglasses and clothing.
1 Observe these instructions and keep them located
near the Li-ion Battery for future reference.
Work on the Li-ion Battery should be carried out by
qualified personnel only.
2 Any uncovered battery material such as electrolyte
or powder on the skin or in the eyes must be flushed
with plenty of clean water immediately. Then seek
medical assistance. Spillages on clothing should be
rinsed out with water.
3 Explosion and fire hazard.
Terminals of the Li-ion Battery are always a live;
therefore do not place items or tools on the Li-ion
Battery. Avoid short circuits, too deep discharges
and too high charge currents. Use insulated tools.
Do not wear any metallic items such as watches,
bracelets, et cetera. In case of fire, you must use a
type D, foam or CO2 fire extinguisher.
4 Never try to open or dismantle the Li-ion Battery.
Electrolyte is very corrosive. In normal working
conditions contact with the electrolyte is impossi-
ble. If the battery casing is damaged do not touch
the exposed electrolyte or powder because it is cor-
rosive.
5 Too deep discharges damage the Li-ion battery
seriously and can even be dangerous. Therefore, use
of an external safety relay is obligatory.
00_00_ZBP45_EN.book Page 12 Monday, October 19, 2020 9:52 AM

Table of Contents