- 34 -
4.3.4 VE.Bus Inverter/charger
monitoring
4.3.4.1 Input current-limiter setting
This chapter explains the implications of the input
current-limiter setting, as seen here in the menu:
It specifies the maximum allowable input current for
inlet connections.
The limit must be set by the user through the
potentiometer R10.
Depending on the generator/mains connection you
connected, the setting value must be adjusted
according to the following table:
00_00_ZBP45_EN.book Page 34 Monday, October 19, 2020 9:52 AM
To Next Page
Loading...