- 33 -
When using a VE.Bus system, it is possible to
configure the severity of problems on the VE.Bus
system that should cause a notification to show up on
the CCGX (and make it beep):
– Disabled: The CCGX will never beep or show a
notification.
– Alarm only: The CCGX will only beep and show
a notification when the VE.Bus system switched
off in an alarm condition.
– Enabled (default): The CCGX will beep and show
a notification.
When all done, don't forget to change the access level
to user when required.
4.3.3 Battery State of Charge (SOC)
There are three products types that calculate State Of
Charge (SOC). The CCGX itself does not calculate
SOC, it only retrieves it from the connected devices.
In the ZBP45 and ZBE45, we use the Multi and
Quattro inverter/chargers.
Details on VE.Bus SOC
While the Inverter/Charger is in bulk, the SOC will
not rise above the value as set in VEConfigure3 for
the “State of charge when Bulk finished“ parameter
on the General tab; default 85%. In a system with
Solar chargers, make sure that the Absorption voltage
as configured in the MPPT is slightly above the same
setting in the inverter/charger. The latter needs to
recognize that the battery voltage has reached the
absorption level. If it doesn’t, the SOC will be stuck
at the earlier mentioned End-of-bulk percentage,
default 85%.
Generator start/stop
Configure generator autostart settings and conditions.
Tank pump
Configure automatic starting and stopping of pump based on tank level(sender) information. Pump auto start/stop with Color Control GX.
Relay
Function Alarm relay Select the relay function. Possible functions are ‘Alarm relay’, ‘Generator start/stop’, ‘Tank pump’ and ‘None’ (disabled).
Polarity Normally open
Select the polarity of the relay on the back of the CCGX. ‘Normally open’ or ‘Normally closed’. (Note that setting it to normally closed
increases the CCGX power draw.)
Services
ModbusTCP Off This setting enables the ModbusTCP service.
VRM two-way
communication
No Enable remote configuration and firmware updates. VE Power Setup manual.
Item Default Description
00_00_ZBP45_EN.book Page 33 Monday, October 19, 2020 9:52 AM
To Next Page
Loading...