- 21 -
3 Installation and connection
3.1 Lifting
The lifting eye, to lift the ESS by means of a hoist, is
integrated in the bodywork and easily accessible from
the outside.
When lifting the ESS, the hoist has to be placed in
such a way that the ESS, which must be placed
leveled, will be lifted vertically.
To be able to lift the ESS by means of a forklift,
forklift slots (2) are provided in the frame at each side
of the unit.
3.2 Positioning and transport
3.2.1 Positioning for operation
Follow the steps below to position the ESS. The
installation location must be selected according to the
following criteria:
1. Place the ESS on a horizontal, even and solid
floor.
2. Protect it from unauthorized access.
3. Ensure that your ESS is never placed in a water
puddle that is deeper than the slots for the forklift
transport (7 cm).
4. The unit should be as close as possible to its
sources of energy (diesel generator, PV system,
mobile PV, grid) and grounding point.
5. Keep the ventilation openings clear and a keep a
minimum distance of 50 cm to the left and right of
all objects that might obstruct the ventilation of
the appliance.
6. If several ESSs are placed next to each other, a
minimum distance of 100 cm between the devices
must be maintained.
7. In the case of permanent use on vehicles,
additional measures must be taken to prevent
vibrations (for example decoupling via vibration
dampers).
8. Ensure that the unit is not exposed to saline or
particularly aggressive solvents (such as ammonia
fumes in agriculture), as this may adversely affect
the life of the components.
9. Avoid large temperature fluctuations. If there are
too many differences, condensation may form
inside the housing, causing a short circuit.
10. Once the ESS is correctly positioned, install a
suitable earthing and make sure that it is correctly
connected to the ESS.
For more detailed installation instructions, see also
chapter “Installation” on page 23.
Lifting acceleration and deceleration
must be kept within safe limits (max.
2 g).
Helicopter lifting is not allowed.
The operator is expected to apply all
relevant safety precautions, includ-
ing those mentioned on page 8 to
page 12 of this booklet.
00_00_ZBP45_EN.book Page 21 Monday, October 19, 2020 9:52 AM
To Next Page
Loading...