MSBR Series 13 Mediant 800 MSBR
Hardware Installation Manual 2. Unpacking the Device
2 Unpacking the Device
Follow the procedure below for unpacking the carton in which the device was shipped.
To unpack the device:
1. Open the carton and carefully remove packing materials.
2. Remove the chassis from the carton.
3. Check that there is no equipment damage.
4. Ensure that in addition to the chassis, the package contains the following items:
• Four anti-slide bumpers for desktop installation
• Two mounting brackets for 19-inch rack mounting
• One FXS Lifeline splitter cable adapter (only for models with FXS interfaces)
• Three Wi-Fi antennas (depending on ordered model)
• One E1/T1 splitter cable adapter (RJ-45 male to two RJ-45 female shielded) for
E1/T1 WAN interface (only for devices ordered with a single E1/T1 WAN port)
• Serial cable adapter
• One AC power cable
5. Check, retain and process any documents.
If there are any damaged or missing items, notify your AudioCodes sales representative.
To Next Page
Loading...
Need help?
General
