AudioCodes Mediant 800 - 6 Cabling the Device; Grounding and Surge Protection

MSBR Series 33 Mediant 800 MSBR
Hardware Installation Manual 6. Cabling the Device
6 Cabling the Device
This section describes the cabling of the device, which includes the following:

Grounding (earthing) the device – see Section 6.1 on page 33

Connecting to the WAN – see Section 6.2 on page 33

Connecting to the LAN – see Section 6.3 on page 43

Connecting PoE-enabled equipment – see Section 6.4 on page 44

Connecting the FXS interfaces – see Section 6.5.1 on page 45

Connecting to Analog Devices – see Section 6.5.2 on page 46

Connecting the Analog Lifeline – see Section 6.5.3 on page 47

Connecting to BRI lines – see Section 6.6.1 on page 48

Connecting the PSTN Fallback for BRI Lines – see Section 6.6.2 on page 49

Connecting E1/T1 trunks – see Section 6.7 on page 50

Connecting to a computer for serial communication – see Section 6.8 on page 51

Connecting a USB storage device – see Section 6.9 on page 48

Connecting the OSN server – see Section 6.10 on page 55

Connecting to the power supply – see Section 6.11 on page 57
6.1 Grounding and Surge Protection
The device must be connected to earth (grounded) using an equipment-earthing conductor.
Protective Earthing
The equipment is classified as Class I EN60950 and UL60950 and must be
earthed at all times.
For Finland: "Laite on liltettava suojamaadoituskoskettimilla varustettuun
pistorasiaan."
For Norway: "Apparatet rna tilkoples jordet stikkontakt."
For Sweden: "Apparaten skall anslutas till jordat uttag."