Configuration Note 5. Configuring the E-SBC Device
Version 1.0 Issue 1.0 55 October 2011
2. Index #1 configuration identifies all IP calls received from the Mediation Server
as IP-to-IP calls and assigns them to the IP Group ID configured for the Lync
Mediation Server as verified Lync assigned telephone numbers within a prefix
range:
• 'Dest Phone Prefix': Enter the asterisk (*) symbol to indicate all destinations.
• ‘Source Phone Prefix': Enter the Lync assigned telephone prefix to screen
for valid direct IP-to-IP calls of PAETEC DIDs assigned to the location.
• 'Source IP Address': Enter the IP address of the Mediation Server.
• 'Trunk Group ID': Enter "-1" to indicate that these calls are IP-to-IP calls.
• ‘IP Profile ID: Enter ‘2’ indicate the IP Profile for Mediation Server.
• 'Source IP Group ID': Enter "2" to assign these calls to the IP Group
pertaining to the Mediation Server.
3. Index #2 configuration identifies all IP calls received from the Mediation Server in
the event of a call forwarding scenario (see Section
5.10 on page 62) as IP-to-IP
calls and assigns them to the IP Group ID configured for the Mediation Server:
• ‘Source Host Prefix: Enter the Lync Front end FQDN – in case of call
forwarding, the Source host in the incoming INVITE from the Mediation
Server is the Lync Front End server FQDN, while for regular calls, the
Source host is the Mediation Server FQDN.
• 'Dest Phone Prefix': Enter the asterisk (*) symbol to indicate all destinations.
• 'Source IP Address': Enter the IP address of the Mediation Server.
• 'Trunk Group ID': Enter "-1" to indicate that these calls are IP-to-IP calls.
• ‘IP Profile ID: Enter ‘3’ to indicate that the IP Profile supports the call
forwarding scenario.
• 'Source IP Group ID': Enter "2" to assign these calls to the IP Group
pertaining to the Mediation Server.
4. Index #3 configuration identifies all IP calls received from PAETEC SIP Trunk as
IP-to-IP calls and assigns them to the IP Group ID configured for the PAETEC
SIP Trunk:
• 'Dest Phone Prefix': Enter the asterisk (*) symbol to indicate all destinations.
• 'Source IP Address': Enter the IP address of PAETEC SIP Trunk.
• 'Trunk Group ID': Enter "-1" to indicate that these calls are IP-to-IP calls.
• ‘IP Profile ID: Enter ‘1’ indicate the IP Profile for PAETEC SIP Trunk.
• 'Source IP Group ID': Enter "1" to assign these calls to the IP Group
pertaining to PAETEC SIP Trunk.
To Next Page
Loading...
Need help?
General
